Hi,
I try doing Lead Acid battery 3D modeling in time-dependent by using LA battery 1D model application in the library. 1D application has two porous electrodes (positive and negative) for electrodes, a separator, a reservoir, and therefore no flux is applied on all boundaries. But, in my 3D application, electrodes and porous electrodes have been selected for each electrodes domains. That is, I draw two electrode domains that are positive and negative electrodes, a separator, and a reservoir that is electrolyte. Porous electrode domain in the middle area, and electrode domain for border of electrode have been selected for each electrode domain. If I choose just porous electrode for whole electrode area, no flux is applied on all boundaries, that is desired condition. However, if I choose porous electrode and electrode domain for each electrode, no flux is not applied on electrode boundaires where in borders. But I want to apply no flux for all boundaries. How can I do it?
Thank you
I try doing Lead Acid battery 3D modeling in time-dependent by using LA battery 1D model application in the library. 1D application has two porous electrodes (positive and negative) for electrodes, a separator, a reservoir, and therefore no flux is applied on all boundaries. But, in my 3D application, electrodes and porous electrodes have been selected for each electrodes domains. That is, I draw two electrode domains that are positive and negative electrodes, a separator, and a reservoir that is electrolyte. Porous electrode domain in the middle area, and electrode domain for border of electrode have been selected for each electrode domain. If I choose just porous electrode for whole electrode area, no flux is applied on all boundaries, that is desired condition. However, if I choose porous electrode and electrode domain for each electrode, no flux is not applied on electrode boundaires where in borders. But I want to apply no flux for all boundaries. How can I do it?
Thank you
